
New fireplace and insert installation for New Jersey homes — wood, gas and prefab systems, vented, lined and finished to code.
A new fireplace is three projects wearing one coat: the appliance itself, the venting system that serves it, and the clearances and finishes around it. Get any one wrong and the other two do not matter. We install wood-burning and gas fireplaces, fireplace inserts and prefab systems across our New Jersey service area, handling the flue and liner work in-house — the part most installers subcontract and the part that decides whether the fireplace drafts, heats and lasts.
Every installation starts with the venting plan, not the showroom choice: flue sizing, chimney height, liner specification and makeup air are worked out for your house first, then matched to the unit you want. The result is a fireplace that lights easily, drafts cleanly and passes inspection — documented with the same photo-and-paper trail as every other job we do.
Tell us about your chimney or gas fireplace — we confirm every request by phone. Prefer to talk? Call (855) 424-6217.
A fireplace insert converts an open, drafty fireplace into a real heating appliance — a sealed stove body set into the existing firebox, vented through a full stainless liner. It is the single most popular installation we do in Monmouth and Ocean County homes, and the liner is where jobs succeed or fail: a full-length, correctly sized, insulated liner drafts properly and can be swept like a chimney, while a short stub connection saves money on day one and causes smoke and creosote problems for years. We install full liners, period.
Gas units — inserts, log sets and direct-vent fireplaces — trade wood heat for instant, clean convenience, and they still need correct venting and an annual service habit. We install the fireplace side and coordinate the gas line with licensed gas fitters where the run requires it, then commission the unit and walk you through operation. If you are converting an existing wood fireplace to gas, the flue and liner assessment comes first — see our gas fireplace service page for how conversions are scoped.
This work is searched for by many names. Every service below is performed as part of — or booked through — this one:
In many homes, yes — a prefab chimney system or direct-vent gas unit can be added where no masonry chimney exists. The assessment covers structure, venting route and clearances, and we will tell you plainly if your layout does not support it.
Yes — a full-length stainless liner sized to the insert is part of a correct installation, and it is included in how we scope every insert job. It is also what makes future sweeping and inspection straightforward.
The fireplace, venting and commissioning are ours. Gas piping is run or extended by licensed gas fitters — we coordinate with them regularly and sequence the work so the installation finishes in one project, not three.
An insert with liner is typically one to two days. A new prefab system or masonry work runs longer and is scheduled as a scoped project with the timeline in writing before we start.
Installations are performed to the manufacturer’s specification and applicable code requirements, and we support any permit or inspection process your township requires — ask us at the assessment and we will outline what applies to your town.
A full sweep of the flue, firebox and smoke chamber — creosote gone, draft restored, and a written condition report before we leave.
Learn more →
Level 1 and Level 2 chimney inspections with camera scanning, a photo report and straight answers — for annual checks, home sales and after a chimney fire.
Learn more →
The annual inspection for chimneys in regular service: every accessible part checked, condition documented, safety confirmed for another season.
Learn more →
Camera inspection of the entire flue, plus attics, crawl spaces and concealed areas — the inspection for home sales, chimney fires and appliance changes.
Learn more →